Manual

System Connections
24
3.1.2 Connecting SAS RAID System Controller to the Host
1. Insert the SAS cable into the CH1 port.
2. Insert the other end to the HBA connector of the host server.
3.2 Connecting the GUI Management Port
To easily monitor and configure the RAID system, use the Graphical User
Interface (GUI). To manage the GUI, a LAN/WAN connection is required.
Follow the procedures below:
1. Insert the ethernet cable to the LAN port of the controller.
2. Connect the other end to the LAN switch.
Note
The illustration below shows A16R-SS RAID system. The same
procudures apply for A12R-SS and A24R-SS.
Note
• The illustration above shows A16R-SS. The same procedures apply
to A12R-FS&SS, A16R-FS, and A24R-FS&SS.
• Please refer to the software user manual to configure IP address to
access the GUI.
Figure 3-1 Connecting A16R-FS to LAN