Owner's manual

Accusys A12R/U-FS&SS / A16R/U-FS&SS / A24R/U-FS&SS

6. Go to System Setup > Save Config > Save to NVRAM > YES in the menu

to save your settings.

Set up through CLI

The Command Line Interface (CLI) is a set of commands which allows

users to configure or monitor the RAID system by entering lines of text

through a variety of the terminal consoles.

The embedded CLI can be accessed remotely by the Ethernet (TCP/IP)

and locally by the RS232 terminal. And by Ethernet, you may use Telnet

and SSH (Secure Shell).

Telnet client software is available for all operating systems, and you can

download the SSH client software from the following web sites:

SSHWinClient: http://www.ssh.com/

PuTTY: http://www.chiark.greenend.org.uk/~sgtatham/putty/

To set up the IP Address through CLI:

1. Establish LAN communications with the RAID controller. See Step 4.

Setting Up LAN Connections on page 16 for more details.

2. Open your terminal program and log in to CLI using the following

information:

•User name: admin

•Password: 0000

3. Use the following command to set up the IP address.

Note

When LAN or WAN is not available, use a HUB or crossover LAN

cables to connect to a computer to setup IP then manage the RAID

system by GUI. Set the IP as follows:

Controller A LAN = 192.168.1.1

Controller B LAN = 192.168.0.1

Command ethsetaddr

Synopsis ethsetaddr ethx method [-a] ip_addr [-s] net_mask [-

g] gw_addr [-d] dns_addr [-z] on/off

Description Set IP address of an Ethernet port

Parameters method: static or dhcp

[-a]: network address

[-s]: network mask

[-g]: gateway address

[-d]: DNS server address

[-z]: Automatic Private IP Addressing (APIPA)