Owner's manual

Accusys A12R/U-FS&SS / A16R/U-FS&SS / A24R/U-FS&SS
31
5. Select a LUN ID from the drop-down menu.
6. Select a virtual disk from the drop-down menu for LUN mapping.
7. Click Apply to start LUN mapping.
8. Repeat steps2 to 6 until you assigned all the disks.
For example:
9. Click RAID Management to see if the Mapping is correct.
By CLI
10. Use the following command to add a LUN ID to a virtual disk.
For example:
CLI>htpaddlun fcpa1 dg1ld0
CLI>htpaddlun fcpa1 dg0ld0
CLI>htpaddlun fcpa2 dg1ld0
CLI>htpaddlun fcpa2 dg0ld0
CLI>htpaddlun fcpb1 dg1ld0
CLI>htpaddlun fcpb1 dg0ld0
CLI>htpaddlun fcpb2 dg1ld0
CLI>htpaddlun fcpb2 dg0ld0
11. Type htplistlun all to see if the Mapping is correct.
Command htpaddlun
Synopsis htpaddlun fcpx/sasx jbdy/dgyldz/voly/vvoly [-l lunz] [-
s
512b/1kb/2kb/4kb] [-g cylinder head sector] [-w wt/
wb]
htpaddlun scpx jbdy/dgyldz/voly/vvoly [-i scsi_id]
[-l lunz] [-s 512b/1kb/2kb/4kb] [-g cylinder head sec-
tor] [-w wt/wb]
Description Add a LUN in a FC port with a virtual disk
Parameters [-i scsi_id]: SCSI ID
Refer to sgaddlun for other parameters.