Owner's manual

Accusys A12R/U-FS&SS / A16R/U-FS&SS / A24R/U-FS&SS
48
The Web GUI can not
be connected.
The management network
interface is not configured
properly.
Check if the LED indicators of the
Ethernet port are lit up properly
(refer to the hardware manual for
details), and the IP address has to
be set to enable the network
interface. You can manually set the
IP address by the LCD or local CLI,
or use a DHCP server on the
network.
The replacement
controller stops boot-
up with LCD
messages.
Configuration conflict
discovered by the system.
The beeper alerts, and the
LCD shows the following mes-
sages:
(A) CONTR MOD UNEQ: the
two controllers are of differ-
ent model.
(B) DB UNEQ: the two control-
lers have different daughter
board.
(C) PLD VERS UNEQ: the two
controllers have different PLD
version.
(D) MEM SZ UNEQ: the two
controllers install memory of
different size.
(E) BBM INSTL UNEQ: one con-
troller has BBM, while the
other has no BBM.
If the conflict configuration
can be resolved by overwrit-
ing the configuration of the
replacement controller, the
following LCD messages will
be displayed and waiting for
your confirmation by LCD ENT
button:
( F) CHK BC VERS: the two
controllers have different
boot code version.
(G) CHK FW VERS: the two
controllers have different firm-
ware code version.
(H) CHK BBM OPT: the two
controllers have different BBM
option.
( I ) CHK SN UNEQ: the two
controllers belong to
different enclosures.
(A/B/C) Contact your RAID system
supplier to get the correct control-
ler.
(D/E) Install proper memory
module and BBM.
For (F) and (G), press the ENT
button on the LCD to update the
boot code and firmware code,
respectively, and the replacement
controller will reboot.
For (H) and (I), press the ENT button
to overwrite the BBM and enclosure
serial number, and the replace-
ment controller will continue boot-
up.