User Manual

Using the LCD Consolel
3-7
3.3.3 Network Settings
In Ethernet Setup menu, users can view the network status and configure
the server settings. Use the UP and DOWN buttons to scroll through the
following items, and press the ENT button to select.
Users can enter the IP related settings according to the following IP
format.
IP format: “xxx.xxx.xxx.xxx”, where x is {0, 1, ..., 9}.
Use the UP and DOWN buttons to select the numbers 0 to 9. Press the ENT
button to enter the number. To cancel the selection, backspace, and
return to the previous level (if IP is empty), press the ESC button.
3.3.4 Terminal Port Settings
To configure the settings of terminal port, enter the Terminal Port menu.
Specify the following items one by one.
Use the UP and DOWN buttons to scroll through the options. Press the ENT
button to select it. To cancel the selection and return to the previous
level, press the ESC button.
Select CTL ID (For redundant-controller system only) Selects the
controller you want to configure.
Status Displays the connection status.
Set DHCP ENABLE (default) / DISABLE
If DHCP is disabled, the system will require you to enter an
IP address, net mask, gateway, and DNS. These settings
are configured in the sequence as shown.
MAC Address Display MAC address.
Baud Rate 2400, 4800, 9600, 19200, 38400, 57600, 115200 (default)
Stop Bit 1 (default), 2
Data Bit 7, 8 (default)
Parity NONE (default), ODD, EVEN
Flow control OFF (default), H/W