User Manual

Using the CLI Commands
4-38
Command
beeper
Synopsis
beeper on/off/mute
Description
Review or set the beeper.
Command
fwupdate
Synopsis
fwupdate image.bin [-b] [-c ctlx]
Description
Upload the firmware image or update the boot code with
the file, image.bin.
Parameters
[-b]: update boot code
[-c ctlx] (for redundant controller only): target controller to
update
Command
fwupdateprog
Synopsis
fwupdateprog [-c ctlx]
Description
List the current firmware update progress.
Parameters
[-c ctlx] (for redundant controller only): target controller to
get firmware update progress
Command
batterylist
Synopsis
batterylist ctlx
Description
List the status of the battery installed in a controller.
Command
ctldst
Synopsis
ctldst on/off
Description
Enable or disable the detailed self test of controller during
start-up.
Command
diagdump
Synopsis
diagdump diag.bin [-p]
Description
Export extensive diagnostics information from the controller
to a file. This command only works on local CLI run on the
host computer and dosen’t work on remote CLI via telnet,
SSH, or RS232.
Parameters
[-p] Dump diagnostics of peer controller (for redundant
controller only)
Command
nandflash
Synopsis
nandflash primary/secondary
Description
Show the current status of the on-board NAND flash chips.