User Manual

Appendix
D-41
SAS
• Hosts
• Link
Event ID
0x300c
Type
HOST
Severity
INFO
Parameters
Host WWPN,
Host Port ID
Message
Host x detected on host port y
Description
The controller detected host x on host port y. The host can start
access the controller over the host port.
Advice
None
Event ID
0x300d
Type
HOST
Severity
INFO
Parameters
Host Port ID,
phy ID
Message
Host port x phy y link up
Description
The link on the host port x phy y had been built by the controller
successfully, and data transferring can be started.
Advice
None
Event ID
0x300e
Type
HOST
Severity
NOTICE
Parameters
Host Port ID,
phy ID
Message
Host port x phy y link down
Description
The link on the host port x phy y had been turned down by the
controller, and data transferring was posed. This happens when
the host port was disconnected from host HBA or switch because
of removing/powering down/resetting the host or switch, or
removing the cables.
Advice
If the link unexpectedly disconnects, or it happens continuously
during host access, check the host connectivity, or contact local
sales or support office.