User Manual
Table Of Contents
- Notice
- About This Guide
- Guide to Conventions
- Trademarks
- Table of content
- Table of Figures
- 1. Introducing ExaSAN PCIe2.0 Storage Systems
- 2. Preparing to Install ExaSAN B08S2-PS
- 3. Installing the ExaSAN B08S2-PS
- 4. Using RAIDGuardX GUI
- 4.1 Accessing the RAIDGuardX GUI
- 4.1.1 RAIDGuard X Client and Server
- 4.1.2 RAIDGuard X Menu Bar
- 4.1.3 Updating the ExaSAN RAID system Firmware
- 4.1 Accessing the RAIDGuardX GUI
- 5. RAID Overview
- 6. Appendices
3. Installation
User Guide Page 3-18
Go to Control Panel -> System Properties -> Hardware -> Device Manager (depending on the version
of Windows, the path may vary). If the driver has been correctly installed, the HBA is listed with the
ACS-6xxxx identifier (actual name may vary) as Storage Controllers.
Figure 32: device manager in Windows platform
Caution
If you see the HBA listed as an unknown device under Windows, follow the
driver installation steps to reinstall the driver. If you do not see the HBA under
Device Manager, Windows does not detect the card. Power off the host server
to reseat the HBA.
3.3.6 Confirm LEDs on HBA
Verify the Jumper Switch LED, Link LED, and Access LED on the backplane of the HBA are
appropriately lit according to your installation (Refer to Section 1.5.2 ExaSAN QSFP Host Bus Adapter).
If the LEDs are not on, please refer to the Appendix A FAQ Q3.