User's Manual

6
Start unconditional transfer Icons area
Show quantity of electricity of
battery
Icons area
Missed call records Icons area
Note: the icons shall be subject to change without any further notice.
2.4 Battery
The battery was charged about 50% electrical power, it is available to use immediately
after the phone is unpacked. For the first three times, the power must be run out of, and then
the battery should be fully charged to use, thus the battery can supply in the best service
condition.
1. Remove and install the battery
 Dismantle by following procedures:
①Remove cover of battery of the mobile phone.
②Lift the bottom of battery upward and remove it from battery box.
Warning: power off before removing the battery. When the phone is power on or
connected to external power supply, it is forbidden to remove the battery, or the SIM
card and phone would be damaged.
 Install by following procedures:
Align the metal contact point of battery with that of battery box, and snap the battery in
the box and press the battery downward until it is installed well.
2. Charge
 Insert the charger on the supply.
 Connect the right end of charger to the side port of mobile phone.
 After connection, the screen of mobile phone displays “The charger was connected”,
and it is charging, the battery icon shows the process of charge; if the phone was power off,