Users Manual

M2Smart
®
SE_Set_Brief Overview_V1.02_en_es_fr 7 / 32
ATTENTION
Do not set the modules near heat sources (heater blowers, etc.)
and never subject them to direct solar radiation, excess quantities
of dust or shocks. Make sure that there is no stumbling hazard due
to connection cable or power supplies.
ATTENTION
The modules may not be used in areas subject to explosion.
ATTENTION
Before using the modules, any connection cables must be
checked for damage. Damaged parts must be replaced. For this,
please contact ACD Elektronik GmbH.
ATTENTION
Before use, the contacts of the modules and the contacts of any
plugs present must be checked for dirt and cleaned if necessary.
ATTENTION
Unintended use of the interfaces is forbidden.
ATTENTION
To prevent overheating, the modules may not be covered during
operation.
ATTENTION
The modules may only be opened by trained specialized
personnel.
ATTENTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.

NOTE
This is a Class A device (EN55032). This device can cause radio
interference in residential areas.
In this case, the operator can be asked to take appropriate actions.