User Manual

INSTRUCTION SHEET
KEY FOB PROGRAMMING INSTRUCTIONS -
20925551, 20925554
FOR AUTOMOBILES:
These vehicles can be programmed using the
instructions below:
• 2010 Cadillac Escalade
• 2010 Cadillac Escalade ESV
• 2010 Chevrolet Suburban 1500
• 2010 Chevrolet Tahoe
• 2010 GMC Yukon
• 2010 GMC Yukon XL 1500
These vehicles require the use of a professional scan
tool for programming (see your local GM dealer or
ACDelco Professional Service Center):
• 2011-2014 Cadillac Escalade
• 2011-2014 Cadillac Escalade ESV
• 2011-2014 Chevrolet Suburban 1500
• 2011-2011 Chevrolet Suburban 2500
• 2011-2014 Chevrolet Tahoe
• 2011-2014 GMC Yukon
• 2011-2014 GMC Yukon XL 1500
PROGRAMMING INSTRUCTIONS
This procedure will erase all previously learned transmitters. Therefore,
they must be relearned as additional transmitters.
FOR VEHICLES WITH DRIVER INFORMATION CENTER (DIC):
1. Press the vehicle information button until PRESS  TO
RELEARN REMOTE KEY displays.
2. Press the set/reset button until REMOTE KEY LEARNING ACTIVE
is displayed.
3. Press and hold the lock and unlock buttons on the first transmitter
at the same time for about 15 seconds.
On vehicles with memory recall seats, the first transmitter learned
will match driver 1 and the second will match driver 2. A chime will
sound indicating that the transmitter is matched.
4. To match additional transmitters at this time, repeat Step 3.
5. To exit the programming mode, you must cycle the key to LOCK/OFF.
FOR VEHICLES WITHOUT DRIVER INFORMATION CENTER (DIC):
To access this display, the vehicle must be in park
1. Press the trip odometer reset stem until RELEARN REMOTE KEY
displays.
2. Press and hold the trip odometer reset stem for three seconds.
The message REMOTE KEY LEARNING ACTIVE will display.
3. Press and hold the lock and unlock buttons on the first transmitter
at the same time for about 15 seconds.
On vehicles with memory recall seats, the first transmitter learned
will match driver 1 and the second will match driver 2. A chime will
sound indicating that the transmitter is matched.
4. To match additional transmitters at this time, repeat Step 3.
5. To exit the programming mode, you must cycle the key to LOCK.