Use and Care Manual

1English1
English -11
Mounting Cutting Discs
To fit a cutting disc, proceed as follows:
1. Make sure the grinder spindle is at standstill.
2. Locate the lock plate onto the machines spindle.
3. Locate the disc against the lock plate.
4. Screw the lock nut onto the spindle.
5. Push the spindle lock button to the lock spindle and tighten the lock nut with the
two-pin wrench supplied.
For cutting, while using a depressed center disc, use the machine at an angle of
90
to cut the target surface.
NOTE