USER GUIDE MODEL: TA-7850
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: . Reorient or relocate the receiving antenna. . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which the receiver is connected . Consult the dealer or an experienced radio/TV technician for help.
This symbol on a product means that the product is covered by European Directive 2012/19/EU. Inform yourself about the local separate collection system for electrical and electronic products. Follow local rules and never dispose of the product with normal household waste. Correct disposal of old products helps prevent negative consequences for the environment and human health. Batteries Do not dispose of used batteries in the household rubbish.
IMPORTANT SAFETY INSTRUCTIONS 1. Read these Instructions. 2. Keep these Instructions. 3. Heed all Warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including ampliers) that produce heat. 9.
16. Water and Moisture - This product should be kept away from direct contact with liquids. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. 17. CAUTION – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. Batteries (a battery pack or an installed battery) shall not be exposes to excessive heat such as sunshine, re, etc. 18.
INSIDE THE BOX TA-7850 Alarm Clock, AC power adaptor, plastic wall plug. tapping screws(4 pcs), steel rope, DC head plastic holder, rubber plug. AC outlet AC POWER SOURCE Insert the small end of the AC adaptor into the DC In Jack(located on the rear of the unit). Connect the other end to a wall outlet providing 100-240V AC, 50/60 Hz. The output of the provided AC/DC Adaptor is DC 5V 5A. note: Disconnect both ends of the power cord when not in use.
LOCATION OF CONTROLS 1 2 3 4 5 6 7 9 8 10 11 12 14 13 1 AUDIO OFF button 2 Volume + button 3 FM RADIO button 4 TUNE/SKIP - button 5 BLUETOOTH button 6 PLAY button 7 LINE IN button 8 Volume - button 9 TUNE/SKIP + button 10 ALARM ON-OFF switch 11 ALARM SET MINUTE button 12 ALARM SET HOUR button 13 ALARM LOUDNESS switch 14 SNOOZE button
15 16 17 18 19 20 21 LCD Display indicators 22 1 15 USB Charging port 16 Dimmer button 17 USB Charging port 18 Screw jack 19 DC In jack 20 Line-In jack 21 Backup battery compartment 22 HOUR ADJUST button 23 TIME SET button 23 2 3 1 Time display 8 DST 2 Line-In/AUX 4 9 DIMMER ON/OFF 3 Bluetooth 6 10 Day of the week 4 FM Radio 5 Radio PRESET 6 Day/Night 7 AM/PM Time 5 7 8 11 AM/PM (ALARM ) 12 ALARM Set Time 13 ALARM 9 13 12 11 10
BACKUP BATTERY Charge Time Plus with a built-in backup battery, which is for prevention from data lost due to power disconnection and saves the date and time to make setup simpler. The date and time are saved for PST(Pacific Standard Time) There's also an internal capacitor that is used for backup to save time and alarm settings during a power failure or if the AC adapter is unplugged. Since this is built-in there is no need to replace any batteries to maintain the power backup feature.
SETTING THE CLOCK AND DATE 1. Plug in the ChargeTime-plus, but leave the power "OFF". 2. Press and hold the TIME SET button until the display flashes "12" then press the TUNE/SKIP - or TUNE/SKIP + button repeatedly to advance to the correct hour. 3. Press the TIME SET button to confirm and now the digits "00" will begin flashing. Pressing the TUNE/SKIP - or TUNE/SKIP + button repeatedly to adjust the minutes. 4. When you reach the correct current minute, press the TIME SET button again to confirm. 5.
SILENCING THE ALARM 1. When the alarm sounds, press the AUDIO OFF button to silence the alarm. 2. The Alarm On will appear on the display, indicating that the alarm is reset and will sound again in 24 hours. DISABLING THE ALARM 1. If the alarm is not needed the next day, slide the ALARM switch to the "OFF" position and the Alarm Off will display, indiacting that the alarm is off and will not sound. 2.
NIGHT MODE 1. When the unit is in "NIGHT MODE" , the night mode icon " " will flash 3 times, and then the display will go blank. When any button is pressed, the display brightness will turn on to medium brightness for 7 seconds . 2. Press the "DIMMER" button on front under the LCD. Repeatedly to cycle through the brightness levels of the LCD display and choose from: high, medium, low and night mode. The default setting is medium. AUTO DST: 1. Auto-DST by default will ship as "on". 2.
PLAYING THE RADIO 1. With the ChargeTime-plus plugged in, press the RADIO button to enter the RADIO mode and the FM frequency will appear on the display. 2. Repeatedly press the TUNE/SKIP - or TUNE/SKIP + button to manually adjust the tuning on the display until the desired station appears. 3. For auto tuning, press and hold the TUNE/SKIP - or TUNE/SKIP + button until the display starts to scan then release the button and the tuner will search and stop on the next strongest station it finds.
STREAMING BLUETOOTH AUDIO 1. With the ChargeTime-plus plugged in, press the BLUETOOTH button into the Bluetooth mode and the BT icon will appear on the display. 2. Power on your Bluetooth compatible device and search for the ChargeTime-plus under the Bluetooth settings of your audio streaming device. After a few seconds it should detect the ChargeTime-plus, at which time you can select the ChargeTime-plus and establish a wireless Bluetooth connection. 3.
AUDIO OFF Press AUDIO OFF to turn off all audio. DUAL USB CHARGING PORTS The ChargeTime-plus features dual USB charging ports on the front of the unit which are designed to charge most USB compatible devices. Simply plug in a USB cable (sold separately) into the ChargeTime-plus USB port then connect your device to begin charging. SPECIFICATIONS general: Power Source..............................................................................................................................................
FAQS Q: Why is the USB port not charging my devices? A: Make sure that the USB plug is firmly connected into both ports of the ChargeTime-plus and your USB compatible device and that the ChargeTime-plus is plugged in to a power source as the USB charging ports will not operate from the backup batteries.
CONTACT DETAILS Europe Americas Middle East Asia TeleAdapt Limited Axis 5 Rhodes Way Watford WD24 4YW United Kingdom Tel: +44 (0)1923 810200 TeleAdapt Inc 1315 Greg Street Suite 110 Sparks NV 89431 USA Tel: +1 775 355 8585 TeleAdapt Limited Dubai Media City Thuraya Tower 1 Office 1008 PO Box 500344 Dubai UAE Tel: +971 367 8283 TeleAdapt HK, Ltd Unit G, 15/F, Block 2 Leader Industrial Center No.
