Product Manual

2. Vent the pressurized air from the
6. NOTE: USE SODA BLAST MEDIA
delivery unit using the vessel valve
ONLY. USE OF OTHER MEDIA
located on the top of the pressure
TYPES WILL VOID ALL
vessel unit. Turn valve slowly (earplugs
WARRANTIES AND COULD CAUSE
recommended) releasing air pressure.
PERSONAL INJURY!
7. Remove funnel and REPLACE
SAFTEY CAP onto the pressure vessel
media inlet fitting. Making sure it is
tightly secured.
8. Shut ball valve on vacuum inlet by
turning 90 degrees from inlet. (closed)
3. CHECK TO MAKE SURE SYSTEM IS
TOTALLY DEPRESSURIZED.
4. CAREFULLY remove safety cap from
pressure vessel media inlet fitting,
MAKING SURE ALL AIR IS DELETED
FROM VESSEL.
9. Turn on air supply.
10. Remove shutout lock from Air Safety
valve. Move Air Safety valve to on
position. (up)
4.3 Operation
This section covers the safe operation of
the Model 2-PS.
1. Put on protective equipment before
operating the unit.
5. Use clean plastic funnel to slowly pour
unused dry soda into unit.
2. Make sure air and water feed lines are
Wear appropriate filtered mask while
attached and turned on.
loading and unloading soda.
3. Unwind blasting feed hose so there
are no kinks or coiled portions (as with
all blasting, the least amount of sharp
bends in the hose the better).
10