Product Manual

4. With your free hand placed under the 7. Disconnect the large air supply hose

control unit (so as to not let it drop), (top of control unit) by loosening hose

completely unscrew the union, clamp (slide clamp up onto hose).

allowing the control unit to separate

from the pressure vessel (place a small

container under the pressure vessel to

catch any remaining soda).

8. Disconnect the large blast nozzle feed

hose (bottom of control unit) by

loosening hose clamp (slide clamp up

onto hose).

5. Tip the control unit upside down, to

empty any soda that may still be in the

inlet fitting. With a pair of needle nose

pliers, remove the factory installed

1/8” restrictor and place it in a safe

place.

9. Place the control unit on a clean and

stable work surface, and remove the

four (4) Allen head machine screws

from the cover. Remove cover.

6. Disconnect the 1/8” air feed tube from

the control unit air cylinder. Place a

small piece of tape over the ends so

as not to get dirt or debris into tube or

cylinder

10. With a socket wrench, 2” extension

and 9/16”socket, carefully loosen the

two (2) controller adjustment bolts

(back of control unit above and below

the air cylinder), until both bolts are

completely loose. Set