Product Manual

15. Reassemble the control unit, using the 17. Place compression spring and spring
following steps. Slide (2) hose clamps plate onto the end of the pincher plate
onto each control tube. Slide one end in recessed area, making sure the
onto a barbed nipple in the control spring plate is 90 degrees from the
housing, and the other end on the control tubes. Using (2) long
barbed nipple directly across from first adjustment bolts (washers next to
nipple. MAKE SURE HOSE CLAMP head of bolt) carefully thread each bolt
BOLTS ARE ON THE SIDE CLOSEST evenly into the spring plate (spring
TO THE CENTER OF HOUSING. plate recess area is to be against
Repeat for other control tube. Slide spring, make sure spring is centered in
clamps to end of each tube and recess areas on both plates).
tighten securely with 5/16” socket
wrench with extension.
18. Tighten the adjustment bolts evenly.
Note: picture shown without cylinder
MAKE SURE TO TURN EACH BOLT
assembly for better viewing.
ONE (1) TURN AND THEN THE
OTHER SO AS TO ADJUST THEM
DO NOT remove cylinder assembly.
EVENLY - IT IS CRITICAL THAT THEY
16. Slide pincher plate onto cylinder shaft
ARE ADJUSTED EQUALLY - FAILURE
and attach with the shaft nut, making
TO ADJUST EQUALLY WILL DAMAGE
sure pincher bars are directly centered
THE CONTROL UNIT.
over the control tubes. (Use a flat
Turn the bolts equally until the end of
blade screwdriver or wrench to extend
each bolt is 1” from the surface of the
the cylinder shaft for ease of
spring plate (note: NOT from the
assembly).
20