Product Manual
Table Of Contents
• Remote Blast Control • Pressure Vessel: ASME Code
- Automatic Shut-off if Handle • Working Pressure-Range: 30 to 120 PSI
Pressure is Released • Compressed Air Minimum: 80 PSI @ 18
- Control at Nozzle Handle CFM
- System Shuts Off at the Tank • Soda Blast Media Capacity: 100 Lbs.
• Blast Hood with Bump Cap (included)- Dry Blast
Added Safety Protection for the
Operator 3.0 Assembly
• Contains Features Usually Available
To assemble the Model 2-PS, simply
Only on More Expensive Models
connect and tighten the 1/2”NPT pipe
2.2 Site Requirements union at the top of the unit with a pipe
wrench or channel lock. Make sure the
Several factors are considered essential
union is secure.
when determining an acceptable work
site environment for the Model 2-PS. 3.1 Start-Up Instructions
These requirements include:
1. Connect the Model 2-PS to a source of
• The work site should be as smooth clean, dry compressed air, capable of
and level, as possible, to allow easy delivering a minimum of 80 PSI at 18
movement and adjustment of the CFM. The compressor must produce
equipment. sufficient air pressure and volume to
• The work site must be well ventilated. convey abrasive from the blast unit to
• The work site should have sufficient the surface. Connect the source of
lighting. compressed air onto safety lock out
• The Model 2-PS should not be placed valve inlet. NOTE: Connect airline
near open flames, sparks or welding directly to avoid airflow restriction. DO
devices. NOT use quick disconnect fittings.
• A source of compressed air with a
minimum pressure of 80 PSI @ 18
CFM.
2.3 Specifications
Basic Design and Requirements
• Dimensions: 48”H x 21”W x 25”D
• Weight: 135 LBS (approx.)
• Water: Standard hose connection
(3/4”) and 30-90 PSI clean water
• Material: 14 & 11 gauge Steel
• Abrasive Resistant Hose: 25 ft. long,
1/2”I.D. (optional lengths available to
75 ft.)
• Nozzle: 1/8”Standard (other sizes
optional- 3/32” thru 1/4”)
• Restrictor: 1/8”Standard
(5/32”optional)
7