MSDS

MATERIAL SAFETY DATA SHEET ACE™ Instant Cold Pack 207513, 207514,486934, 901051, 906001 and Futoro™ Instant Cold
Pack 800000 03/01/12
_________________________________________________________________________________________________
Page 3 of 6
accordance with good industrial hygiene practice. Warning! A motor could be an ignition source and could cause flammable gases or
vapors in the spill area to burn or explode.
6.2. Environmental precautions
For larger spills, cover drains and build dikes to prevent entry into sewer systems or bodies of water. Place in a closed container
approved for transportation by appropriate authorities. Dispose of collected material as soon as possible.
Clean-up methods
Observe precautions from other sections. Call 3M- HELPS line (1-800-364-3577) for more information on handling and managing the
spill. Contain spill. Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially available
inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Collect as much of the spilled material as possible.
Clean up residue with water.
In the event of a release of this material, the user should determine if the release qualifies as reportable according to
local, state, and federal regulations.
SECTION 7: HANDLING AND STORAGE
7.1 HANDLING
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below Occupational Exposure Limits.
If ventilation is not adequate, use respiratory protection equipment.
7.2 STORAGE
Store away from heat. Store out of direct sunlight.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 ENGINEERING CONTROLS
Not applicable.
8.2 PERSONAL PROTECTIVE EQUIPMENT (PPE)
8.2.1 Eye/Face Protection
Avoid eye contact.
8.2.2 Skin Protection
Not applicable.
8.2.3 Respiratory Protection
Under normal use conditions, airborne exposures are not expected to be significant enough to require respiratory protection.
8.2.4 Prevention of Swallowing
Not applicable.
8.3 EXPOSURE GUIDELINES
Ingredient Authority Type Limit Additional Information
UREA AIHA TWA, as total
particulates
10 mg/m3