User Manual

Here are descriptions of every setup items:
SSID
Please input the SSID (the name used to identify this wireless access point)
here. Up to 32 numerical characters can be accepted here, excepting space.
TX Rate
Please select the data transfer rate here. The maximum TX rate you can select
here depends on the wireless mode you’re using. It’s safe to select ‘Auto’ to let
wireless card select a proper TX rate according to the strength and quality of
radio signal. When the wireless mode is set to ‘802.11 B/G/N Mix’, TX Rate will
be set to ‘Auto’ and cannot be changed.
Channel
Please select the wireless channel you wish to use. The number of channels
available here will vary depends on the setting of ‘Country Region Code’.
Wireless Mode
Please select the wireless operating mode. You can limit the type of wireless
client to 802.11b or 802.11g only, or allow 802.11b/g, and 802.11b/g/n clients.
It’s safe to select ‘802.11 B/G/N mix’ to allow all kinds of wireless client to
connect to your computer, unless you want to limit the type of wireless client
allowed to connect to your computer.
Use Mac Address
Click this button to use the MAC address of the wireless card as SSID. A prefix
of ‘AP’ will be added.
Security Setting
Set the security options (wireless data encryption). Please refer to chapter 3-2
‘Security Settings’ for details.
Country Region Code
Please select the country code of the country or region you live. Available
options are 0-7, which will affect the available wireless channels you can use:
0: FCC (US, Canada, and other countries uses FCC radio communication
standards)
1: ETSI (Europe)
2: SPAIN
3: FRANCE
4: MKK
5: MKKI (TELEC)
6: ISERAL (Channel 3 to 9)
7: ISERAL (Channel 5 to 13)
Wireless Protection
Wireless protection will prevent data collision when there are both 802.11b and
802.11g clients. You can select ‘Auto’ to let configuration utility to decide to use
wireless protection or not. You can also select ‘ON’ or ‘OFF’ to force the use of
wireless protection or not.