User Manual

-5-
NOTICE
1. If somehow you cannot get video output, please try to adjust EDID dip switch to “[pin1,
pin2]=[↓-↑-]” for trouble shooting. If “[pin1, pin2]=[↓-↑-]” still cannot work, please
switch to “[pin1, pin2]=[↓-↓]” to learn the EDID from output 1 to customize the EDID
information.
(Please note that the display with lowest resolution must be connected to output 1)
Select to [pin1, pin2]=[↓-↓] - Learning EDID from output 1
(1) Set the rotary switch to ↓-↓]
(2) Power on the device
(3) It will automatically learn EDID from output 1
 If you would like to keep Ultra HD video on display and go with the legacy HDMI Amplifiers (Full HD) in
the environment, please ↑-↓
Select to [pin1, pin2]=[↑-↓] AVR MODE
(1) [pin1, pin2]=[↑-↓]”
(2) Power on the device
[NOTE] Please power cycle the device after re-setting dip switch.
2. Firmware update is proceeded through Micro-USB.
(1) Save the firmware file (.bin) & software in the same folder.
(2) Connect the Micro-USB cable between PC and device
(3) Open firmware update software and then device will start to update firmware automatically.
(4) After
automatically.
(5) Power cycle the device