User's Manual
Table Of Contents
- TravelMate 2000/2500
- Revision History
- Copyright
- Conventions
- Preface
- Table of Contents
- Ch.1 System Introduction
- Ch.2 System Utilities
- Ch.3 Machine Disassembly and Replacement
- General Information
- Disassembly Procedure Flowchart
- Removing the Battery
- Removing the Memory Module
- Removing the Wireless LAN Board and the Modem Board
- Removing the Hard Disk Drive Module
- Removing the LCD Module
- Disassembling the LCD Module
- Disassembling the Main Unit
- Removing the Keyboard
- Removing the RTC Battery
- Removing the Fan
- Removing the Thermal Module
- Removing the Processor
- Installing the Processor
- Removing the Upper Case Assemly
- Removing the Touchpad Board
- Removing the Touchpad Cable
- Removing the VGA Thermal Plate
- Removing the CPU Heatsink Plate
- Removing the Second Fan Bracket
- Removing the ODD Module(1)
- Removing the ODD Module(2)
- Removing the HDD Bracket
- Removing the Main Board
- Removing the DC Board
- Removing the I/O Port Bracket
- Removing the PCMCIA Slot
- Removing the Speaker Set
- System Upgrade Procedure
- Ch.4 Troubleshooting
- Ch.5 Jumper and Connector Locations
- Ch.6 FRU (Field Replaceable Unit) List
- App.A Model Definition and Configuration
- App.B Test Compatible Components
- App.C Online Support Information
57 Chapter 3
3. Remove the two screws and then detach the launch board from the middle cover.
Removing the LCD Module
1. See “Removing the Battery” on page 52.
2. See “Removing the Middle Cover” on page 56.
3. See “Removing the Launch Board” on page 56.
4. Remove the screw that fastens the LCD coaxial cable and disconnect the cable. Then disconnect the
LCD inverter cable.
5. Remove the four screws holding the LCD hinge; two on the right and two on the left.Remove the four
screws holding the LCD hinge; two on the right and two on the left.
6. Remove the two screws on the bottom; one on the right and the other on the left.
7. Then you can remove the entire LCD module from the main unit.