Instruction Manual

32 Chapter 2
The following table describes the parameters in this sub-menu. Settings in boldface are the default and
suggested parameter settings.
Setting the Boot Drive Sequence
The Boot Drive Sequence section lists boot priorities (1st, 2nd, 3rd and 4th) for bootable drives in your
computer.
For example, the default value (1st:Floppy Disk, 2nd:CD-ROM, 3rd:HDD and 4th:LANDesk (R) Service Agent)
tells the computer to first search for a bootable floppy disk in the floppy drive. If it finds one present, it boots up
from that floppy disk. If not, the computer continues to search for a bootable CD-ROM in the CD-ROM drive.
If it cannot boot up from the CD-ROM, it continues by booting up from the Hard Disk.
To set the boot drive sequence, use the cursor up/down keys to select a priority level (1st, 2nd, 3rd or 4th);
then use the cursor left/right keys to select the device for that priority level.
Parameter Description Options
Boot Display Sets the display on boot-up.
When set to
Auto
, the computer automatically
determines the display device when the computer
starts up. If an external display device (e.g.,
monitor) is connected, it becomes the boot display;
otherwise, the computer LCD is the boot display.
When set to
Both
, the computer outputs to both the
computer LCD and an external display device if
one is connected.
Both
or Auto
Screen Expansion Enables or disables the screen expansion feature.
When enabled, DOS screens expand to fill the
LCD.
Enabled
or Disabled
Resume on LAN/Modem
Access
When enabled, allows your computer to resume
when LAN/Modem access is active
Enabled
or Disabled
Hotkey Beep Enables or disables a system beep when a hotkey
or key combination is pressed.
Enabled
or Disabled
Fast Boot Fast Boot allows your computer to boot up and
resume from Sleep mode (including Standby and
Hibernation modes) faster. When enabled, the
operating system and BIOS communicate
information about Plug-and-Play resources and
previous boot-ups.
Enabled
or Disabled
Boot on LAN When enabled, allows your computer to boot by
other computer or server through the LAN. And the
LANDesk (R) Service Agent in Boot Drive
Sequence item will be enabled.
Disabled
or Enabled
Boot Drive Sequence Specifies the order in which the computer starts up
from. See the section below.
1st: Floppy Disk,
2nd: CD-ROM/DVD-ROM/
CD-RW,
3rd: HDD
4th: LANDesk (R) Service
Agent
Intel(R) SpeedStep(TM)
technology
Intel SpeedStep technology allows your computer
to automatically adjust the CPU speed depending
on the power source. If set to Automatic, system
will adjust the processor speed by OS. f the power
source is supplied by AC adapter, processor will
run at the maximum speed. If the power source is
supplied by battery, processor will run at the
minimum speed.
Automatic
Maximum Performance
Battery Optimized
Reversed