Router User Guide

AcerRouter 700 Series User Guide 3-25

User Name: the name of the remote system’s user name that is dialing in.

This field is case sensitive.

User Password: the password associated with the user name above. This

field is case sensitive.

Note: Authentication is Either, meaning that CHAP will be used to authen

ticate the incoming call, and if that fails, then PAP will be used.

Step 6 Select APPLY to add the connection profile to the AcerRouter 700’s

database, or select ADVANCED for more options and proceed to the next

section.

Advanced Options for Dial-in Profiles

If you press the Advanced button from the Single User Dial-in by ISDN screen, the

following screen appears.

Note: The IPX options shown in this screen only appear if you selected Share Ne

tWare (IPX) Resource on the SMART Configuration screen.

Step 1 Enter the following information:.

Caller ID Authen: select Yes if you want the AcerRouter 700 to check the

caller ID before accepting the call. This service may require a special agre

ement with your ISDN service provider.

Caller ID Number: if you enabled Caller ID Authentication, enter the expe

cted Caller ID Number in this field.

STAC Compression: allows outgoing data to be compressed to achieve

higher throughput, and compressed incoming data to be recognized. The

ability to use compression depends on the capabilities of the ISP.

Connection Profile Configuration

Idle Timeout (0-3600 seconds)

120

Single User Dial-in by ISDN

Enable IP

Enable IPX

Caller ID Authen.

Yes

Caller ID Number

ISDN Link Usage

Two “B” Channels only when needed

STAC Compression

Enable encryption

Encryption key

Yes

Remote IPX Network Number

DES

CANCEL OK

MULTILINK