User Guide

AcerPower 2000 User’s Guide4-20
4.5.3 Installing the Celeron CPU
Observe the ESD precautions when installing or
removing a system component. See section
4.1.1.
Before you proceed, make sure that there is no processor installed in the CPU
connector.
Follow these steps to install a Celeron processor:
1. Remove the Celeron processor from its protective packaging.
2. Lower the processor into the CPU socket and gently push it in until the
golden fingers completely fit into the connector.
Figure 4-20 Installing the Celeron Processor
3. Connect the 3-pin cable to JPX1 and the 2-pin cable to JP8 on the system
board.