User Guide

ManualsBrandsAcer ManualsOtherAF715

Before operating the monitor please read this manual thoroughly. This

manual should be retained for future reference.

Contents

Packing list ------------------------------------------------------

Precautions ------------------------------------------------------

Installation Instructions --------------------------------------

Swivel Base ----------------------------------------------------

Power cord ---------------------------------------------------

Video cable ---------------------------------------------------

Operating Instructions ---------------------------------------

General Instructions ---------------------------------------

Front panel control -----------------------------------------

How to adjust a setting ------------------------------------

Adjusting the picture ---------------------------------------

6-8

Plug and play ---------------------------------------------------

Technical Support (FAQ) ------------------------------------

Appendix A – Specifications----------------------------------

11-12

Appendix B – Factory Preset Timing Table --------------

Summary of content (15 pages)

PAGE 1
Before operating the monitor please read this manual thoroughly. This manual should be retained for future reference.
PAGE 2
PACKING LIST The product package should include the following items: 1. Pure Flat Color Monitor 2. Owner's Manual 3. Power Cord 1.
PAGE 3
PRECAUTIONS z Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. z Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause serious damage to the appliance. Use only a cart or stand recommended by the manufacturer or sold with the monitor. If you mount the monitor on a wall or shelf, use a mounting kit approved by the manufacturer and follow the kit instructions.
PAGE 4
INSTALLATION INSTRUCTIONS Swivel Base To attach the swivel base to the monitor, do the following: • Carefully turn the monitor on its side or upside down. ( see figure 1 ) • Locate the cavities at the bottom front of the monitor. • Insert the pegs on the swivel base into these cavities. Push the swivel base forward until the swivel base locks in place. • To remove the swivel base, hold the bottom of the swivel base, then push it out.
PAGE 5
Connecting the Video Cable: the monitor comes with a built-in video cable. Plug the signal cable′s 15-pin connector into the computer's video port and tighten the two screws on the cable connector.(see figure 2) Caution:Don’t bend the signal cable, otherwise it will break the inner wire. Connecting the Power Cord: Plug the power cord into the monitor's AC power jack. Then plug the power cord into a grounded AC outlet, ULapproved power strip, or the power output socket on your PC.
PAGE 6
OPERATING INSTRUCTIONS General Instructions The power switch is located at front panel of the monitor. Press the power switch to turn the monitor on or off. The other control knobs are located at the base of the monitor (See Figure 3). By changing these settings, the picture can be adjusted to your personal preferences. • The power cord should be connected. • Connect the video cable from the monitor to the video card. • To turn the monitor on, press the POWER switch to ON position.
PAGE 7
FRONT PANEL CONTROL • Power: Press this knob to switch ON/OFF of monitor’s power. • MENU : Active OSD menu or function adjust confirm. • Contrast / : Adjust contrast or function adjust. • Brightness / : Adjust brightness or function adjust. • EXIT : Exit a function or inactive OSD menu. • Power Indicator : Green — Power On mode. Orange — Off mode. OPTIMUM PICTURE FOR THE SBQ FUNCTION 1. 2. 3. 4.
PAGE 8
PAGE 9
How to adjust a setting The monitor controls are accessed by pressing button MENU to enable OSD (On-Screen-Display). The main menu will be displayed as follows. Figure 4 The OSD Message Note: If adjustment or selection of any OSD menu is not made for more than 10 seconds, the current setup will be saved and the OSD will disappear automatically. Adjusting the picture The description for functional control icons 1. CONTRAST Adjust the picture contrast. 2. BRIGHTNESS 3. Adjust the picture brightness.
PAGE 10
. PIN-BALANCE : Adjust to compensate the pincushion unbalance. : 11. PARALLELOGRAM Adjust the picture to be a rectangle. : 12. ROTATION Adjust the picture tilt to horizontal position. 13. 6500K /9300K (COLOR TEMPERATURE) : The color temperature for 6500°K is x=0.313, y=0.329 and 9300°K is x=0.283, y=0.297. It presents two different color sets on the screen. You can select 9300°K or 6500°K by pressing MENU Key. : 14.
PAGE 11
THIS MONITOR WILL APPEAR TO BE NON-FUNCTIONAL IF THERE IS NO VIDEO INPUT SIGNAL. IN ORDER FOR THIS MONITOR TO OPERATE PROPERLY, THERE MUST BE A VIDEO INPUT SIGNAL. This monitor meets the Green Monitor standards as set by the Video Electronics Standards Association (VESA) and/or the United States Environmental Protection Agency (EPA) and the Swedish Confederation Employees ( NUTEK ).
PAGE 12
TECHNICAL SUPPORT (FAQ) Problem & Question Power LED is not on No Plug & Play Picture is fuzzy Picture bounces or a wave pattern is present in the picture The power LED is ON (orange) but there’s no video or no picture.
PAGE 13
APPENDIX A - SPECIFICATIONS CRT Viewable Image Size Display Color • Analog input Input Signal • Video • Sync. Synchronization • Horizontal • Vertical Max. Resolution Video Dot Rate Factory Preset Timings : User mode Timings : Misconvergence • Center • Corner Power Source 43.2cm(17"), pure flat and 90º deflection, 29mm neck, 0.25mm dot pitch non-glare screen. 40.6cm (16"), diagonal Unlimited colors All timing that meets scanning frequencies Specification • Analog R, G, B 0.
PAGE 14
FUNCTIONS Plug & Play EPA On mode ENERGY Off mode STAR® Power consumption Preset display area Regulations • • • • CONTRAST BRIGHTNESS H-CENTER H-SIZE • • • • • • • • • • • • • • • • V-CENTER V-SIZE ZOOM PINCUSHION TRAPEZOID PIN-BALANCE PARALLELOGRAM ROTATION 6500˚K USER COLOR 9300˚K DEGAUSS MOIRE REDUCE RECALL EXIT SELECT LANGUAGE DDC1/2B ≤120W ≤3W 120 Watts Max.
PAGE 15
STANDARD IBM VGA VESA/85 VESA/85 VESA/85 VESA/85 VESA/85 VESA/75 RESOLUTION 720 x 400 640 x 480 640 x 480 800 x 600 1024 x 768 1280 x 960 1280 x 1024 1600 x 1200 HORIZONTAL FREQUENCY 31.5kHz 31.5kHz 43.3kHz 53.7kHz 68.7kHz 85.9kHz 91.1kHz 93.