System information
12
Altos R380 F2 FAQ (Frequently Asked Questions)
For connection mode:
• Concurrent (Default)
Concurrent (Default)Concurrent (Default)
Concurrent (Default):
::
: All of onboard LAN port 1, onboard LAN port 2 and optional dedicated server
management port can be used for management with different IP address. All NIC ports must be on
different subnet.
• Failover
FailoverFailover
Failover:
::
: All of onboard LAN port 1, onboard LAN port 2 and optional dedicated server management port
are bonded together. The setting of onboard LAN port 1 will be used for bonding. If a connection fails,
Smart Console connection will switch to the others. Failover mode can be enabled in Smart Console.
8. How do I configure the IP address of BMC on Altos R380 F2?
ANS
ANSANS
ANSWER:
WER:WER:
WER: Please enter BIOS Setup during POST.
a. Please select Server Management.
b. Please select BMC LAN Configuration.
c. You would see information below.
Baseboard LAN configuration
IP Source [Static]
IP Address 010.036.060.100
IP Subnet Mask 255.255.255.000
Gateway IP 010.036.060.001
Intel (R) RMM4 LAN Configuration
Intel (R) RMM4 Intel (R) RMM4+DMN
IP Source [Static]
IP Address 010.036.061.100
IP Subnet Mask 255.255.255.000
Gateway IP 010.036.061.001
d. Please specify IP address, IP Subnet Mask, and Default Gateway under Baseboard LAN configuration
for share NIC of onboard LAN port 1.
e. If Altos R380 F2 is installed with Dedicated Management Port, please specify IP address, IP Subnet
Mask, and Default Gateway under Intel (R) RMM4 LAN configuration
f. Please save the settings and exit from BIOS Setup.
9. Can Altos R380 F2 BMC use the same IP address as the one in operating system?
ANSWER:
ANSWER: ANSWER:
ANSWER: No. Please do not use the same IP address for BMC and operating system.
10. Should I unplug the power cord of Altos R380 F2 after I update the BMC firmware or SDR?
ANSWER:
ANSWER:ANSWER:
ANSWER: You do not need to unplug the power cord of Altos R380 F2 after updating the BMC firmware.