Owner's Manual

9 Install the filler panel into the drive bay.

If installing a new optical drive, see succeeding section.

To install a slim-line optical drive:

1 Observe the ESD precautions and pre-installation instructions

described on page 35.

2 If necessary, remove the old optical drive. See previous section.

3 If a filler panel is installed, remove it from the drive bay.

4 Remove the new drive from its protective packaging.

5 Plug the interposer board into the matching connector on the rear

of the optical device.

Note: Make sure the interposer board fits the alignment pin on

drive tray.