Owner's Manual

3 Remove the PCI riser assembly from the server. See “To remove the

PCI riser assembly” section on page 65.

4 While holding the blue release lever in (A), align the holes in the

PCI riser board with the retention pins on the riser assembly.

5 Slide the riser board toward the left (B), then release the blue

lever to lock the board in place.

6 Observe the post-installation instructions described on page 36.

Removing and installing a PCI card

To remove a PCI card:

1 Observe the ESD precautions and pre-installation instructions

described on page 35.

2 Remove the CPU air duct. Perform the instructions described in “To

remove the CPU air duct” section on page 42.

3 Remove the PCI riser assembly from the server. See “To remove the

PCI riser assembly” section on page 65.

4 Open the rear retention clip by pushing the blue slide upward (A)

and rotating clip to the fully open position.

5 When removing a full height PCI riser board, open the full length

PCI card retention clip on the front of the riser assembly by

rotating it 90 degrees outward (B).