Altos User's Guide
Table Of Contents
- Notices
- Important safety instructions
- 1 System tour
- 2 System setup
- 3 System upgrade
- 4 BIOS setup
- 5 Troubleshooting
- Appendix A: Acer Altos R910 rack installation guide
- Appendix B: Memory configuration options
- Appendix C: Integrated SCSI hardware RAID configuration
- Index
3 System upgrade
46
Installing a HDD
Note: To puchase a HDD carrier, contact your local Acer
representative.
1 Perform steps 1 to 4 of the “Removing a HDD” on page 45.
2 Remove the four screws that secure the air baffle to the HDD
carrier (A).
3 Remove the air baffle from the HDD carrier (B).
4 Save the air baffle and screws for later use.
5 Install a hard disk on the HDD carrier, then secure it with the four
screws (A) that came with the HDD carrier (B).
6 With the lever still extended, slide the HDD carrier all the way into
the drive bay.