Altos User's Guide
Table Of Contents
- Notices
- Important safety instructions
- 1 System tour
- 2 System setup
- 3 System upgrade
- 4 BIOS setup
- 5 Troubleshooting
- Appendix A: Acer Altos R910 rack installation guide
- Appendix B: Memory configuration options
- Appendix C: Integrated SCSI hardware RAID configuration
- Index
3 System upgrade
58
DVD drive
Removing the DVD drive
1 Observe the ESD precautions and pre-installation instructions
described on page 33.
2 Disconnect the power and SATA cables from the SATA-to-IDE
converter board on the rear of the media device (A).
3 Press the blue release latch on the media device carrier (B).
4 Slide the media device from the front opening in the faceplate of
the system (C).
Installing the DVD drive
1 Observe the ESD precautions and pre-installation instructions
described on page 33.
2 If necessary, remove the old DVD drive. See previous section.