Altos User's Guide
Table Of Contents
- Notices
- Important safety instructions
- 1 System tour
- 2 System setup
- 3 System upgrade
- 4 BIOS setup
- 5 Troubleshooting
- Appendix A: Acer Altos R910 rack installation guide
- Appendix B: Memory configuration options
- Appendix C: Integrated SCSI hardware RAID configuration
- Index
3 System upgrade
60
5.25-inch drive
The 5.25-inch drive bay allows you to install additional drives such as
another backup hard drive, CD-ROM drive, or a tape drive. These
options provide the system with additional storage capacity.
Installing a 5.25-inch drive
1 Observe the ESD precautions and pre-installation instructions
described on page 33.
2 Push the tabs on both sides of the carrier filler panel (A).
3 Hold the tabs in while pulling the carrier filler panel from the bay
(B).
4 Remove the screws that attach the slide rails to the filler panel.
5 Attach the slide rails to the device.
6 Attach the Y-power cable to the rear of the device.