Altos User's Guide
Table Of Contents
- Notices
- Important safety instructions
- 1 System tour
- 2 System setup
- 3 System upgrade
- 4 BIOS setup
- 5 Troubleshooting
- Appendix A: Acer Altos R910 rack installation guide
- Appendix B: Memory configuration options
- Appendix C: Integrated SCSI hardware RAID configuration
- Index
3 System upgrade
70
Removing a memory board
Caution! Damage to the system occurs if power is not removed
from the system prior to removal or installation of memory
boards.
1 Observe the ESD precautions and pre-installation instructions
described on page 33.
2 Press the latch on the memory board handle to release the handle
(A) and lift the handle up (B).
3 Lift the memory board from the server (C).
4 Install a memory board or memory board air baffle. For
instructions to install a memory board, refer to section below. For
instructions to install a memory board air baffle, refer to
“Installing a memory board air baffle” on page 43.
5 Observe the post-installation instructions described on page 34.