Altos User's Guide
Table Of Contents
- Notices
- Important safety instructions
- 1 System tour
- 2 System setup
- 3 System upgrade
- 4 BIOS setup
- 5 Troubleshooting
- Appendix A: Acer Altos R910 rack installation guide
- Appendix B: Memory configuration options
- Appendix C: Integrated SCSI hardware RAID configuration
- Index
71
Installing a memory board
1 Observe the ESD precautions and pre-installation instructions
described on page 33.
2 Locate an empty memory board slot.
3 If necessary, remove the memory board air baffle. Perform the
instructions described in “Removing a memory board air baffle”
on page 42.
4 Add or replace memory DIMMs as needed. For instructions, see
“Installing and Removing DIMMs”.
5 Make sure the memory board handle is in the open position.
6 Align the board edges with the card guides and slide the memory
board into the memory board slot (A).
7 Push the handle down until it is in the locked position (B).
8 Observe the post-installation instructions described on page 34.