Altos User's Guide
Table Of Contents
- Notices
- Important safety instructions
- 1 System tour
- 2 System setup
- 3 System upgrade
- 4 BIOS setup
- 5 Troubleshooting
- Appendix A: Acer Altos R910 rack installation guide
- Appendix B: Memory configuration options
- Appendix C: Integrated SCSI hardware RAID configuration
- Index
75
8 Install the memory board DIMM cover on the memory board:
(1) Align the DIMM cover tabs with the top of the memory board
(A).
(2) Press the retainer tab inward (B).
(3) Press the DIMM cover down until it clicks into place.
9 Install the memory board. For instructions, see “Hot-insertion of a
Memory Board” on page 54 or “Cold Insertion of a Memory
Board”on page 71, depending on your server configuration.
10 Observe the post-installation instructions described on page 34.
Removing DIMMs
Before you can install a new DIMM in a socket, remove first any
previously installed DIMM from that socket.
Important: Before removing any DIMM from the mainboard,
make sure to create a backup file of all important data.
Caution! Use extreme care when removing DIMMs. Too much
pressure can damage the connector. Apply only enough pressure
on the plastic levers to release the DIMM.
1 Perform steps 1 to 5 described in the “Installing DIMMs” section.
2 Gently pull the DIMM upward to remove it from the socket.