User`s guide

15
English
Installation
Warning Indicator
 When the lamp fails, the indicator goes red and then the
projector will automatically shut itself down. Please contact
your local reseller or service center. See pages 51-52.
 When the projector has overheated, the indicator ashes red
(1.0s on, 1.0s off). The projector will automatically shut itself
down.
Under normal conditions, the projector can be switched on
again after it has cooled down. If the problem persists, you
should contact your local dealer or our service center.
See pages 51-52.
 When the fan fails, the indicator ashes red (2.0s on, 2.0s
off). Please contact your local dealer or our service center.
See pages 51-52.
Powering Off the Projector
1. Press the “ ” button to turn off the projector lamp, you
will see a message displayed on the projector’s screen.
2. Press the “ ” button again to conrm,
otherwise the message will disappear after 15 seconds.
When you press “ ” button second, the system will show
the timing countdown on the screen.
3. The cooling fans continue to operate for about 10 seconds
for cooling cycle. When the Power LED turn ashing
Green (1.0s on, 1.0s off), the projector has entered standby
mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and
has entered standby mode. Once in standby mode, simply
press “ ” button to restart the projector.
4. Disconnect the power cord from the electrical outlet and
the projector.
5. Do not turn on the projector immediately following a
power off procedure.
Downloaded From projector-manual.com Optoma Manuals