Technical information
Table Of Contents
- COVER
- TOC
- System Specifications
- System Utilities
- Entering Setup
- Product Information
- Standard CMOS Setup
- Advanced Setup
- Advanced Chipset Setup
- Integrated Peripherals
- Integrated Peripherals-IDE Function Setup
- Integrated Peripherals-Onboard Device Setup
- Integrated Peripherals -Onboard I/O Chip Setup
- Power Management
- PCI/PnP Setup
- PC Health Status
- Frequency/Voltage Control
- Load Default Settings
- Set Supervisor/User Password
- Save & Exit Setup
- Exit Without Saving
- Machine Disassembly and Replacement
- Troubleshooting
- Jumper and Connector Information
- FRU (Field Replaceable Unit) List
63
Notice:
I. Front panel USB cable must be always connect to M/B USB2 and USB3 port whether
has card reader.
II. The black cable of them is requested to close to the cooler when connecting
“Recovery＂cable.
III. The red cable of them is requested to close to PCI slot with MB when connecting
“Intrusion” cable;
Paste clip/Cable routing
Process:
1. We should paste a cable clip on bottom, Put audio cable into the cable clip
2. Cable routing.
Put audio/USB/Card reader/1394 cable into the cable clip
Paste 1pcs
cable clip