Technical information
Table Of Contents
- COVER
- TOC
- System Specifications
- System Utilities
- Entering Setup
- Product Information
- Standard CMOS Setup
- Advanced Setup
- Advanced Chipset Setup
- Integrated Peripherals
- Integrated Peripherals-IDE Function Setup
- Integrated Peripherals-Onboard Device Setup
- Integrated Peripherals -Onboard I/O Chip Setup
- Power Management
- PCI/PnP Setup
- PC Health Status
- Frequency/Voltage Control
- Load Default Settings
- Set Supervisor/User Password
- Save & Exit Setup
- Exit Without Saving
- Machine Disassembly and Replacement
- Troubleshooting
- Jumper and Connector Information
- FRU (Field Replaceable Unit) List
3
1 S/PDIF-out header (1*4)
1 AUX-In header (1*4)
1 front panel audio header (2*5)
Add HD de-pop CKT (the attachment is the reference, please propose
your solution)
S/N ratio: 90 dB at rear output jack
LAN
Controller: Marvell 8071/8075 Gigabit Ethernet controller (VTM220: 8071,
VTM420: 8075)
Port : 1 x RJ45 rear port for Gigabit Ethernet
Design Criteria:
Should be worked under 10/100/1000Mbs environment
Reserved disable function on both hardware & BIOS side. Default is
enabled
Support DASH 1.0/1.1 feature
USB
Controller: AMD SB700
Ports Quantity: 12 (Should we reserve more header for Front DB)
4 port for rear ports
On-board: 4 2*5 headers
¾ 4 ports for front daughter board
¾ 2 ports for internal card reader.
Connector Pin: standard Intel FPIO pin definition Data transfer rate
support:
USB 2.0/1.1
1394
Controller: Jmicron JM831 1394a controller