Technical data

34 Chapter 2 Planning for Installation and Operation
2.4.4 Air Flow Requirements
The AMS200 subsystem is air-cooled. Air must enter the subsystem through the airflow
intakes at the front of each subsystem and must be exhausted out of the back.
2.4.5 Vibration and Shock Tolerances
Table 2.12 lists the vibration and shock tolerance data for the AMS200 subsystem. The
AMS200 can tolerate vibration and shock within these limits and continue to perform
normally. The user should consider these requirements if installing the AMS200 near large
generators located on the floor above or below the AMS200 subsystem. Generators or any
other source of vibration, if not insulated or shock-mounted, can cause excessive vibration
that may affect the subsystem.
Table 2.12 Vibration and Shock Tolerances
Item Specification
In operation (m/s
2
) 2.5 or less
In non-operation (m/s
2
) 5.0 or less
Vibration
In transport (packed) (m/s
2
) 5.0 or less
In operation (m/s
2
) 20 or less
In non-operation (m/s
2
) 50 or less
Impact
In transport (packed) (m/s
2
) 80 or less
Angle at which the subsystem will turn over (º) 15 or less