Technical information

Chapter 1 17
Above table lists some system memory configurations. You may combine DIMMs with various capacities to
form other combinations.
NOTE:
The shipping specification for DIMM combination is 64MB in slot 1.
NOTE:
The IEEE 802.11b MiniPCI card has two RF connectors mounted, identified as Main and Auxiliary
connector. Since there is only one card variant in this controlled deployment program, it is chosen that
antenna diversity can be obtained by use of an external antenna diversity switch, which is connected to
the Main RF connector, and controlled by DC-switching voltage provided through this connector
System Memory
Item Specification
Memory controlle Built-in 82815E
Onboard memory size 0 MB
DIMM socket numbe 2 sockets
Supports memory size per socket 128 MB
Supports maximum memory size 256MB (128MB x 2)
Supports DIMM type SDRAM
Supports DIMM speed 100 MHz
Supports DIMM voltage 3.3V
Supports DIMM package 144 pin so-DIM
Memory module combinations You can install memory modules in any combinations as long as they match
the above specifications.
Memory Combinations
Slot 1 Slot 2 Total Memory
0 MB 128 MB 128 MB
128 MB 0 MB 128 MB
128 MB 128 MB 256 MB
LAN Interface
Item Specification
LAN Interface/Chipset Intel ICH2-M integreated LAN controller with 82562ET PHY
Supports LAN protocol 10/100 Mbps
LAN connector type RJ45
LAN connector location Rear side
Wireless LAN Interface
Item Specification
Wireless LAN interface Mini PCI interface IEEE 802.11b LAN card
Channel support
Default channel support
Covering the FCC subset of the IEEE802.11b ISM band
Antenna diversity support Enabled or Disabled
Enable/disable radio Support FAA requirement
Encryption support Support both 60(64)-bit Wired Equivalent Privacy (WEP) encryption
and 128-bit RC4 encryption
PCI configuration data PC98/99 compliant