Quick Start Guide

NederlandsEnglish
Quick Start
X INSTALLATION
1. Composite video cable
2. VGA to component/HDTV adapter
3. VGA cable
Note: Connector interface is subject to model's specifications
Y INTERFACE CONNECTOR
Connecting to a Computer
1. Ensure the projector and your computer
are turned off.
2. Connect one end of the VGA cable to the
“VGA IN” connector on the projector;
connect the other end to the VGA
connector on the computer and tighten
the screws.
3. Connect one end of the AC adapter into
one end of the power cord.
4. Connect the other end of the AC adapter
into the DC IN connector on the
projector; connect the other end of the
power cord to an electrical outlet.
Powering On the Projector
1. Turn on the projector first and then the
computer.
2. Adjust the position and focus.
3. Run your presentation.
Powering Off the Projector
1. Press the power button twice.
2. Do not remove AC power cord from
outlet until the projector fan shut down.
Snel starten
X INSTALLATIE
1. Composiet videokabel
2. VGA naar component/HDTV-adapter
3. VGA -kabel
Opmerking: Interface-aansluiting is afhankelijk van de
specificaties van het model
Y INTERFACE-AANSLUITING
Aansluiten op een computer
1. Zorg dat de projector en de computer
zijn uitgeschakeld.
2. Sluit het ene uiteinde van de VGA -kabel
aan op de "VGA IN"-aansluiting van de
projector; sluit het andere uiteinde aan
op de VGA -aansluiting op de computer
en draai de schroeven vast.
3. Sluit het ene uiteinde van de adapter
aan op de stroomkabel.
4. Sluit het andere uiteinde van adapter
aan op de DC IN-aansluiting op de
projector; steek de stekker van de
stroomkabel in een stopcontact.
De projector inschakelen
1. Zet eerst de projector aan en vervolgens
de computer.
2. Pas de positie en focus aan.
3. Geef de presentatie.
De projector uitschakelen
1. Druk tweemaal op de power-toets.
2. Trek de stroomkabel pas uit het
stopcontact als de ventilator van de
projector is gestopt.