User Manual
Table Of Contents
- Acer Aspire 1620 Series User's Guide
- Getting familiar with your computer
- Operating on battery power
- Peripherals and options
- Moving with your computer
- Software
- Troubleshooting
- Appendix A Specifications
- Appendix B Regulation & safety notices
- Energy Star Guidelines Compliance
- FCC notice
- Modem notices
- Important safety instructions
- Laser compliance statement
- LCD pixel statement
- Macrovision copyright protection notice
- Radio Device Regulatory Notice
- General
- The FCC RF safety requirement
- Canada - Low power license-exempt radiocommunication devices (RSS-210)
- Index
63
English
English
• Make sure that the printer is connected to a power outlet and it is
turned on.
• Check that the cable is properly connected to the appropriate
ports on both the computer and the printer.
• If you are using a printer connected to your computer's parallel
port, restart the computer. Windows needs to find the new
hardware and install the necessary drivers.
I want to set up my location to use the internal modem.
Follow these steps:
• Click on Start, and then click on Control Panel.
• Double-click on Phone and Modem Options.
•In the Dialing Rules tab, begin setting up your location.
Refer to Windows Help and Support for more information.
When the battery is 95-99% full, it won't charge to 100% capacity.
To preserve the life of the battery, the system only lets you charge the
battery when its capacity falls below 95%. It is recommended that you
run down the battery, and then fully recharge it.