Technical information

Chapter 4 42
Performance Troubleshooting (Computer Signal)
A. Have Image?
- Ensure the Signal cable and Source work as well.
- Check that can OSD Menu show on the screen.
- Check the Main board.
- Check the DMD board.
B. Have Garbage Pattern?
- Ensure the Signal cable and Source work as well.
- Check the Main board.
- Check the DMD board.
C. Uniformity OK?
- Ensure the Projection screen without dirty.
- Ensure the Projection lens is clean.
- Ensure the Brightness is within spec.
(Replace the Lamp if the Brightnedd is less than spec.)
- Check the Optical engine.
D. Is Color OK?
- Ensure the Signal cable works as well.
- Check the “Color wheel index” in the service mode of OSD Menu. (*Note)
- Check the Photo sensor.
- Check the Main board.
- Check the DMD board.
E. Dot Defect isn’t Compliant with the Spec.
- Ensure the Projection lens is clean.
- Use the Air gun for the Optical engine clean.
- Check the DMD chip.
F. Have Noise?
- Ensure the Signal cable and Source is work as well.
- Adjust the Tracking selection in OSD Menu.
- Press the Menu button to check that have the noise issue appear on OSD Menu.
(Check the DMD board if the noise also appear on the OSD Menu.)