user manual
Table Of Contents
- TravelMate 2000/2500
- Revision History
- Copyright
- Conventions
- Preface
- Table of Contents
- Ch.1 System Introduction
- Ch.2 System Utilities
- Ch.3 Machine Disassembly and Replacement
- General Information
- Disassembly Procedure Flowchart
- Removing the Battery
- Removing the Memory Module
- Removing the Wireless LAN Board and the Modem Board
- Removing the Hard Disk Drive Module
- Removing the LCD Module
- Disassembling the LCD Module
- Disassembling the Main Unit
- Removing the Keyboard
- Removing the RTC Battery
- Removing the Fan
- Removing the Thermal Module
- Removing the Processor
- Installing the Processor
- Removing the Upper Case Assemly
- Removing the Touchpad Board
- Removing the Touchpad Cable
- Removing the VGA Thermal Plate
- Removing the CPU Heatsink Plate
- Removing the Second Fan Bracket
- Removing the ODD Module(1)
- Removing the ODD Module(2)
- Removing the HDD Bracket
- Removing the Main Board
- Removing the DC Board
- Removing the I/O Port Bracket
- Removing the PCMCIA Slot
- Removing the Speaker Set
- System Upgrade Procedure
- Ch.4 Troubleshooting
- Ch.5 Jumper and Connector Locations
- Ch.6 FRU (Field Replaceable Unit) List
- App.A Model Definition and Configuration
- App.B Test Compatible Components
- App.C Online Support Information
Chapter 2 40
DMA channel Sets a DMA channel for the printer to operate in
ECP mode. This parameter is enabled only if Mode
is set to ECP.
DMA3/DMA1
Legacy USB Support Enables, disables USB interface devices support.
(Enable for use with a non-USB aware Operating
System such as DOS or UNIX).
Option:
Disabled or Enabled
Hard Disk Recovery Enables or disables Hard Disk to Hard Disk system
Recovery by pressing Fn+F10 key during POST.
Option:
Disabled or Enabled
Parameter Description Options