user manual
Table Of Contents
- TravelMate 2000/2500
- Revision History
- Copyright
- Conventions
- Preface
- Table of Contents
- Ch.1 System Introduction
- Ch.2 System Utilities
- Ch.3 Machine Disassembly and Replacement
- General Information
- Disassembly Procedure Flowchart
- Removing the Battery
- Removing the Memory Module
- Removing the Wireless LAN Board and the Modem Board
- Removing the Hard Disk Drive Module
- Removing the LCD Module
- Disassembling the LCD Module
- Disassembling the Main Unit
- Removing the Keyboard
- Removing the RTC Battery
- Removing the Fan
- Removing the Thermal Module
- Removing the Processor
- Installing the Processor
- Removing the Upper Case Assemly
- Removing the Touchpad Board
- Removing the Touchpad Cable
- Removing the VGA Thermal Plate
- Removing the CPU Heatsink Plate
- Removing the Second Fan Bracket
- Removing the ODD Module(1)
- Removing the ODD Module(2)
- Removing the HDD Bracket
- Removing the Main Board
- Removing the DC Board
- Removing the I/O Port Bracket
- Removing the PCMCIA Slot
- Removing the Speaker Set
- System Upgrade Procedure
- Ch.4 Troubleshooting
- Ch.5 Jumper and Connector Locations
- Ch.6 FRU (Field Replaceable Unit) List
- App.A Model Definition and Configuration
- App.B Test Compatible Components
- App.C Online Support Information
63 Chapter 3
Disassembling the Main Unit
Removing the Keyboard
1. See “Removing the Battery” on page 52.
2. See “Removing the Middle Cover” on page 56.
3. To remove the keyboard, carefully pull the keyboard out and upwards as the pticute shows.
4. Use a plastic tweezers or a plastic flat screwdriver to disconnect the keyboard cable from the main board
carefully, then remove the keyboard.
Removing the RTC Battery
1. See “Removing the Battery” on page 52.
2. See “Removing the Middle Cover” on page 56.
3. See “Removing the Keyboard” on page 63.
4. Disconnect the RTC battery cable then remove it.
Removing the Fan
1. See “Removing the Battery” on page 52.
2. See “Removing the Middle Cover” on page 56.
3. See “Removing the Keyboard” on page 63.
4. Disconnect the fan cable and remove the three screws fastening the fan. Then remove the fan.