Outdoor Full Color Premium Light Strip Installation Guide
CYNC Direct Connected Outdoor Premium Light strip (16ft.) CYNC Direct Connected Outdoor Premium Light strip (32ft.) What’s included (Devices each sold separately) Light Strip Contents 16 ft. Full Color Light Strip 1. 16 ft. Full Color Light Strip 2. Power supply with plug 3. (15) Mounting clips 4. (15) Mounting screws 5. (1) PCS end cap and glue 32 ft. Full Color Light Strip 1. 32 ft. Full Color Light Strip 2. Power supply with plug 3. (30) Mounting clips 4. (30) Mounting screws 5.
Easy set up Set up your Lights with three easy steps: STEP 1 Connect to the Cync App, powered by Savant STEP 2 Trim to desired length STEP 3 Prep surface and install
Setup in the CYNC app STEP 1 Plug in and power on your light strip by pressing the on/off button on the power supply. STEP 2 Download the Cync App, powered by Savant on your smartphone STEP 3 Add your smart lights to the Cync App For set up help, visit cyncsupport.gelighting.com or call 1-844-302-2943 GE and C by GE are trademarks of General Electric Company. Used under trademark license. Amazon, Alexa, and all related logos are trademarks of Amazon.com, Inc. or its affiliates.
Measure & Trim to Size (If desired) STEP 1 Measure where you’re planning to install your lights. If your space requires Light Strip Extensions, make sure to attach them before trimming your strips. STEP 2 With your Light Strip unplugged, safely cutwhere the trim points are indicated. Make sure the strip is not plugged in at the wall when cutting. NOTE: Cutting anywhere else will permanently damage the strip.
Strip Bending Options
Prep the Surface & Install Your Strip STEP 1 Locate the starting point to install your light strip. Install the first clip by drilling a 1/8-inch hole and screwing in the provided screw. The open ends of the clip should follow the desired direction of your strip. STEP 2 Snap joint Screw Install mounting clips every 13 inches until you reach the end of your light strip. STEP 3 Mount the light strip into the clips by snapping the light strip into each clip.
Extend Strip & Manually Enable Light Shows (If applicable) STEP 1 Unplug the power supply. Screw on the waterproof connector to attach the extension to the light strip. NOTE: 16 ft. Outdoor Strip can be extended up to 32 ft. total. 32 ft. Outdoor Strip can be extended up to 64 ft. total. STEP 2 Light Effects Button Unplug/Plug your strip back in to detect its new length. This is important for Light Effects. ENABLE LIGHT EFFECTS Cycle through light show by pressing the Light Effect button .
FCC Statement Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
TM Like your new Outdoor Full Color Premium Light Strip? Share your experience! Leave a review where you purchased the product.
