User's Manual

2
English
d
d
Remark:
- Please use only the NO. 2 Screws (35 mm x 4 pcs)
provided with this type of installation.
- Please check monitor weight in advance to choose suitable
load capacity of VESA arm stand.
- Do not discard the original screws as these may be needed
for future use.
Attaching the monitor to the base
1. Unpack the box. Take out the Styrofoam
side by side and set flat on the desktop.
2. Take the LCD monitor out of the box
carefully and put it on the side by side
Styrofoam.
3. Press up the quick release button as
illustrated to remove rotary shaft cover.
4. Tighten the rotary shaft, base and stan
arm with three screws. (There will be one
spare screw left.)
5. Attach the base of step 4 to the quick
release notch of the LCD monitor securely.
6. Flip the LCD monitor over to make it stan
upright on the desk where it will be used.
(Note: Do NOT press the screen to avoid
damage any time.)
Lock
Lock
2. Tighten the 4pcs NO.2 screws as Fig
2
1. Remove the ori ginal screws x 4 Fig.
from the opening back of the monitor.
1
3. Connect the monitor onto the wall
Attaching the monitor on the wall
4