User's Manual

EN-18
8. Ultra-Low Latency: Select On to speed up the processing time of the
display switching process.
Adjusting the OSD
1. Press the MENU button to open the OSD.
2. Using the Navi/OK button, select OSD from the OSD. Then navigate to the
setting you wish to change.
3. Use the Navi/OK button to select the setting.
4. Language: Set the OSD menu language.
5. OSD timeout: Adjust the delay before turning the off the OSD menu.
6. Transparency: Select the transparency of the OSD menu. The
transparency can be 0% (OFF), 20%, 40%, 60%, or 80%.
7. OSD Lock: OSD Lock function is used to prevent OSD button from being
pressed acciedntally. To remove the OSD Lock message, press and hold
the Navi/OK button continuously for 3 seconds until the message
disappears. If the OSD Lock message remains, please check whether the
Navi/OK button is stuck.
Note:
1. If Adaptive-Sync is “ON”, then the Ultra-Low Latency is
automatically turned On and grayed out.
2. Ultra-Low Latency is not supported at resolutions below 800 x
600.