Owner's Manual

13
English
Connect to power
Caution: Before you proceed, check the voltage range in your area. Make sure
that it matches your computer's voltage setting. If they don't match, change
your computer's voltage setting according to your area's voltage range.
1 Plug the power cable into the power cable socket located on the rear panel of
your computer.
2 Plug the other end of the power cable into a power outlet.
Turning on your computer
After making sure that you have properly set up the system, applied power, and
connected all the necessary peripherals, you can now power on the system. Follow
the procedure below.
1 Turn on the main power switch located on the rear of the computer.
2 Press the power button.
Important: Make sure that the power cable is properly plugged into an
electrical outlet. If you are using a power strip or an AVR (Auto-Voltage
Regulator), make sure that it is plugged in and turned on.
Turning off your computer
The software procedure below applies to system running a Windows OS. For other
OS shutdown procedures, refer to the related user documentation.
1 On the Windows taskbar, click on the Start button, then click Shut Down.
2 Turn off all peripherals connected to your computer.
If you cannot shut down your computer normally, press and hold the power button
for at least four seconds. Quickly pressing the button may put the computer in
suspend mode only.