Operation Manual

30
Picture 5-27
 Channel: users can type in the channel number that needs to be
connected to the remote device according to their needs.
 Enable: the reversing means selected and the channel enable on/off,
defaulting to be off. Switching on Enable and the related channels
can be previewed and recorded normally.
 Vender Type: Onvif agreement.
 Preview: sub-stream preview is defaulted and IPC port should be
dual-stream. Both should be in the format of H264 code to be
previewed normally and the resolution of the sub-stream can be D1 or
CIF format.
 Protocol: TCP Agreement.
 User name: the login user name of IPC (if the defaulted user name is
not admin, please change it to be valid user name).
 Password: login password of IPC (if the defaulted login password is not
admin, please change it to be valid password).
 IP: IP address of IPC added to NVR.
 Port: defaulting the IPC port to be 8999.
 Save: saving the setup parameters of current channels
 Cancel: going back to the former management interface.
5.3.5 Advance Option
Left-click "Advance Option" in the main menu, as shown below,
including disk management, user accounts, equipment upgrades, and
configuration of four sub-menu preview 5-28.