Operation Manual

42
parameters are same with NVR setting.
Picture 6-10
You can get parameters of Main-stream and Sub-stream of IPC device
of channel access (coding mode, resolution, frame rate, the value of the
stream), also can set the value of stream of Main-stream and Sub-stream of
IPC device by the interface.
6.4.2.3 Motion Detection
Motion detection interface is shown in Picture 6-11, the relevant
parameters consistent with NVR-side settings.
Picture 6-11
The IPC's Main Stream, Sub Stream parameter can be obtained in this
page (Coding mode, Resolution, Frame Rate, Stream Value) the Stream
Value can be adjusted as well.
6.4.3 Rec Setup
6.4.3.1 Common
Rec Setup interface is shown in Figure 6-12.